Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 831)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 815
Identification Description
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MI.VOL Volume for minimum measured value in mL
.MR.MRC Correlation coefficient for mean dosing rate for the
whole range
.MR.MRS Standard deviation for mean dosing rate for the whole
range in mL/min
.MR.MRT Mean dosing rate for the whole range in mL/min.
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in the measuring point list
.RE{x}.DRC Correlation coefficient for mean dosing rate in window
× (1…9)
.RE{x}.DRS Standard deviation for mean dosing rate in window ×
(1…9) in mL/min
.RE{x}.DRT Mean dosing rate in window × (1…9) in mL/min
.RE{x}.RWL Lower limit of the evaluation window × (1…9) in s
.RE{x}.RWH Upper limit of the evaluation window × (1…9) in s
.SLO Electrode slope of the sensor used for the command (in
%)
.SME Start measured value (measured value after processing
the start conditions) in the unit of the measured value
.STE Start temperature (temperature after processing of the
start conditions) in °C
.STY Type of stop with which the command was stopped:
1 = normal;0 = manual or after error
.SVA Start volume absolute (volume that was added accord-
ing to the start condition "start volume") in mL
.SVT Total start volume (volume that was added in depend-
ence on all three start conditions) in mL
.TITER Titer value of the solution used for the command