Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1152)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1136 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Off causes heating at the maximum possible heating rate (see device man-
ual).
Range 1 ... 999 min
Selection off
Default value off
Timeout
If the Target temperature is not reached within the defined Heating
time then this waiting time will start. This parameter is only visible if a
Heating time has been defined.
Range 1 ... 999 min
Selection off
Default value off
Action if timeout expires
on | off (Default value: on)
If this option is enabled, then an action can be defined which is to be carried
out if the target temperature has not yet been reached after expiry of the
maximum waiting time (is displayed only when Timeout ≠ off).
Selection Display message | Stop determination | Stop
determination and series
Default value Display message
Display message
A message is displayed and you can choose whether you want to con-
tinue the run or cancel it.
Stop determination
The determination is stopped and the next determination of the series is
started.
Stop determination and series
Both the determination and the series are stopped and the exit track will
be started (if available).
5.6.7.9 FLOW
5.6.7.9.1 FLOW - Overview
Dialog window: Method ▶ FLOW ▶ Properties... ▶ FLOW - 'Command name'
Command for controlling the gas flow.
Devices
This command can be executed with the following devices:
Sample Processor: 774, 874