Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 130)

3.3 Sample tables ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
114 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Always accept data
If this option is selected, then the data sent from the balance is imported
into the open sample table for which this balance is defined as data
source.
Accept data only for active window
If this option is selected, then the data sent from the balance is only
imported into the open sample table if this is actively selected (i.e. when
the window has the focus).
Confirmation necessary to accept data during determination.
on | off (Default value: off)
If this option is switched on, then data will not be imported during a deter-
mination except when the Data input dialog of a REQUEST command is
open.
Importing from barcode reader
on | off (Default value: off)
If this option is enabled, then external data from the selected barcode read-
ing device will be imported into the opened sample table. The device
properties of the barcode reader will define the field into which the data is
imported (see Chapter 7.18.4, page 1475).
Barcode reader
Selection of the barcode reader from which data is to be imported.
Selection Device name
Selection Always accept data | Accept data only for
active window
Default value Always accept data
Always accept data
If this option is selected, then the data sent from the barcode reader is
imported into the open sample table for which this barcode reader is
defined as data source.
Accept data only for active window
If this option is selected, then the data sent from the barcode reader is
only imported into the open sample table if this is actively selected (i.e.
when the window has the focus).
Confirmation necessary to accept data during determination.
on | off (Default value: off)
If this option is switched on, then data will not be imported during a deter-
mination except when the Data input dialog of a REQUEST command is
open.