Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 51)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 35
Identifica-
tion Description Commands
.CYL Cylinder volume of the exchange or
dosing unit used for the command DET, MET, SET,
KFT, STAT,
STDADD dos,
STDADD auto,
ADD, DOS, LQH,
PREP, EMPTY
.DBL Total duration for the processing of
the command in s DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS,
CAL MEAS,
STDADD, DOS
.DEF Default value which is defined in the
configuration for an IO port ANALOG OUT,
DIGITAL OUT
.DRI Current and/or last drift for drift cor-
rection in µL/min SET, KFT, KFC,
BRC
.DSC Time for processing all start condi-
tions s DET, MET, SET,
KFT, STAT
.DTI Time for drift correction (time from
the start of the titration to the end
of the command) in s SET, KFT, KFC,
BRC
.EGF Last measured gas flow rate (meas-
ured value following processing of
the command) in mL/min MEAS T/FLow
.EME End measured value (measured
value after processing of the com-
mand) in the unit of the measured
value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without REF,
Spec), CAL
MEAS, STDADD,
DOS
.ENP Electrode zero point for the sensor
used for the command (dimension-
less for pH sensor or in mV for the
ISE sensor) and/or electrode zero
point calculated from the calibra-
tion (for STDADD and CAL LOOP) DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS
T, MEAS Conc,
STDADD, CAL
LOOP, DOS
.EP{x}.CHA Load for endpoint x (1…9) in mA·s KFC, BRC