Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1327)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1311
6.7.2.2 Sensors - Column display
Dialog window: Configuration ▶ Sensors ▶ Edit ▶ Column display… ▶ Column display
In the dialog window [Column display], you can define the columns to be
shown in the sensor table.
Columns available
Shows all the fields that can be shown as columns in the Sensor table.
Columns displayed
Shows all the fields that will be shown as columns in the Sensor table. The
default situation is that the columns Sensor name, Sensor type, Meas-
uring input, Set to work, Expiry date, Slope, pH(0)/E(0) and Next
calibration will be shown. The two columns Sensor name and Sensor
type are always present and cannot be removed.
Adds the selected column to the table.
Removes the selected column from the table.
Modifies the sequence of displayed columns by moving the selected column
up and down.
6.7.2.3 Add new sensor
Menu item: Configuration ▶ Sensors ▶ Edit ▶ New
In order to add a new non-intelligent sensor to the Sensor table, the menu
item Edit
▶ New must be pressed and then one of the following possible
sensor types must be selected:
￭ pH electrode
￭ Metal electrode
￭ ISE electrode
￭ Temperature sensor
￭ Conductivity sensor
￭ Other sensor
The Properties window then opens automatically for the configuration of
the sensor (see Chapter 6.7.3.1, page 1313). If the sensor type ISE elec-
trode is selected then the dialog window New ISE electrode will open
first for the definition of the measuring ion.