Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1135)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1119
Move = Special beaker (for 730)
Range
1 ... 8
Default value 1
Move = Special beaker (for 774)
Input
1
Move angle
This parameter specifies the angle by which the sample rack should be rota-
ted relative to the current position. It is only visible for Move = Relative
angle.
778, 789, 814, 815, 855, 864, 874
Range
-259.90 ... 259.90 °
Default value 5.00 °
Beaker test
Selection of the action to be carried out if the beaker sensor defined for the
rack does not detect any beakers at the target position. If the robotic
arm is selected as the beaker sensor, then a Swing Head must be installed.
A work position also defined in the rack data must also be defined in such
a way that a contact exists between beaker sensor and beaker. This work
position will be approached automatically for beaker recognition after the
command MOVE. This section is not visible when Move = Relative
angle.
Selection Display message | Stop determination | Stop
determination and series
Default value Display message
Display message
A message is displayed and the determination is stopped.
Stop determination
The determination is stopped and the next determination of the series is
started.
Stop determination and series
The determination as well as the series are stopped. An Exit track will be
started if there is one defined.
Parameters
Shift rate
Selection of the speed at which the sample rack rotates.