Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1479)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1463
Input 50 characters
Default value Device type number_#
Device type
Display of the device type.
Program version
Shows the program version of the device.
Only visible with devices that have their own firmware.
[Update]
Opens the dialog window Load new program version (see Chapter
7.1.6, page 1371).
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Start-up
Shows the date on which the device was automatically added to the device
table.
Data storage under legal control
Indicates whether the balance has its own calibratable data memory.
Only visible and editable with Sartorius balances.
Selection
on | off
Default value off
Remarks
Remarks about the device.
Input 1000 characters
Default value empty
7.16.3 Properties - RS-232
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ RS-232
The properties of the RS-232 interface are defined on this tab.
COM Port
Selection of the serial interface on the PC to which the device is connected.