Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 965)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 949
Identifica-
tion Description
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.LP.CAx Calculated value × (1...3) for the last measuring point of
the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.GFL Gas flow value for the last measuring point of the meas-
uring point list in mL/min
.LP.MEA Measured value (temperature) for the last measuring
point of the measuring point list in the unit of the meas-
ured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point of the measuring
point list is reached
.MA.MEA Maximum measured value (temperature) in the unit of
the measured value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MI.MEA Minimum measured value (temperature) in the unit of
the measured value
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MN.MEA Average of the measured value in the unit of the meas-
ured value
.NMP Number of measuring points in the measuring point list
.STY Type of stop with which the command was stopped: 1
= normal;0 = manual or after error
5.6.4.8.2 MEAS T/Flow - General/Hardware
Tab: Method ▶ MEAS T/Flow ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters