Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 50)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
34 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Identifica-
tion Description Commands
.BSY Command status; 1 = BUSY,
HOLD or ERROR; 0 = READY;
invalid (variable not available) =
Command has never been started All except START
and END
.C0 Coefficient c0 of the calibration
curve CAL Spec
.C1 Coefficient c0 of the calibration
curve CAL Spec
.C2 Coefficient c0 of the calibration
curve CAL Spec
.C3 Coefficient c0 of the calibration
curve CAL Spec
.CAL Status of the calibration: 1 = cali-
brated normally, 0 = canceled,
because reference wavelength was
not found. CAL Spec
.CBY Command status; 1 = Condition-
ing activated, 0 = Conditioning
deactivated SET, KFT, KFC,
BRC
.CLC Cell constant of the sensor used in
the command (with conductivity
sensors) MEAS Cond, CAL
Cond
.COK Command status; 1 = Condition
requirement fulfilled, 0 = Con-
dition requirement not fulfilled SET, KFT, KFC,
BRC
.CONC Concentration of the solution used
for the command DET, MET, SET,
KFT, STAT, ADD,
DOS, LQH,
STDADD
.CP{#}.MEA Measured wavelength of the cali-
bration point in nm. If no measured
peak can be assigned, then not
found will be entered. CAL Spec
.CP{#}.REF Reference wavelength of the cali-
bration point in nm. CAL Spec