Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1494)

7.19 IO controller ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1478 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
7.19 IO controller
7.19.1 IO controller - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device
type' - 'Device name'
The properties of an IO controller are set on the following tabs:
￭ (see Chapter 7.19.2, page 1478)
General device information such as device name, device type, serial num-
ber, etc.
￭ (see Chapter 7.19.3, page 1479)
General settings for the IO controller.
￭ (see Chapter 7.19.4, page 1480)
Digital inputs of the IO controller.
￭ (see Chapter 7.19.5, page 1483)
Digital outputs of the IO controller.
￭ (see Chapter 7.19.6, page 1486)
Analog inputs of the IO controller.
￭ (see Chapter 7.19.7, page 1488)
Analog outputs of the IO controller.
￭ (see Chapter 6.6.3.8, page 1306)
Information on GLP tests and GLP monitoring.
7.19.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
Device name
Name of device (can be freely defined by user).
Input 50 characters
Default value Device type number_#
Device type
Display or selection of the device type.
Wrapper version
Display of the version of AdsWrapper.dll.
Firmware version
Display of the SPS firmware version on the bus controller. Combined of the
bus controller firmware and the version of the bus controller program.
AdsDll version
Display of the version of AdsDll.dll.