Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 644)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
628 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Dosing device
Dosing device
Selection of the number of the dosing device (dosing or exchange unit) with
which the solution is to be dosed. All the dosing device connections which
are possible with the selected device type are displayed.
Titrando
Selection
1 | 2 | 3 | 4
Default value 1
855
Selection
1 | 2 | 3
Default value 1
Titrino
Selection
internal D0
736, 751, 799
Selection
internal D0 | external D1 | external D2
Default value internal D0
Solution
Input of a solution name or selection of a solution from the solutions defined
in the solution table. If intelligent exchange or dosing units are used, then
a check will be made in the method sequence to see whether the correct
solution has been set on the selected dosing device and whether the dosing
device type is correct. With non-intelligent exchange or dosing units, only
the cylinder volume is checked. At the start of the command, a check is made
of the working life, the validity of the titer and the GLP test interval for the
selected solution.
Input 24 characters
Selection 'Solution name' | not defined
Default value not defined
not defined
No tests will be carried out.
Sensor
Measuring input
Selection of the measuring input to which the sensor is connected.
Titrando
Selection
1 | 2
Default value 1