Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 323)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 307
4.5.2.6.4 Modifications
4.5.2.6.4.1 Modifications - Overview
Subwindow: Database ▶ Determination overview ▶ Determinations ▶ Reproc-
ess... ▶ Reprocessing ▶ Modifications
In the subwindow Modifications of the dialog window Reprocessing
modifications can be made on the following 4 tabs:
￭ Variables
Modification of the variables used in the selected determination.
￭ Method
Modification of the method used in the selected determination.
￭ Statistics
Modification of statistics data.
The tab Statistics will only be shown when the last determination (and
only this one) is selected from a set of determinations which, because of
the statistics defined in the method, belong together.
￭ Curve evaluation
Manual modification of the curve evaluation.
The tab Curve evaluation is only shown when a single determination
is selected that contains curves that can be evaluated.
4.5.2.6.4.2 Modifications - Variables
Tab: Database ▶ Determination overview ▶ Determinations ▶ Reproc-
ess... ▶ Reprocessing ▶ Modifications ▶ Variables
On the tab Variables the variables used in the determination can be modi-
fied.
Variable table
The variable table shows those variables used that are present in all the
selected determinations and cannot be edited directly. With a click on the
column title (columns Variable, Value) the table can be sorted according
to the selected column in increasing or decreasing order.
Variable
Shows the name of the variable. This shows the method variables
(MV.'Name') defined in the START command, the common variables
(CV.'Name') used in calculation and other commands as well as the com-
mand variables 'Name'.TITER, 'Name'.CONC, 'Name'.SLO,
'Name'.ENP and 'Name'.BLV.
Value
Display of the variable value. If a fixed value is defined for a variable, the
value will be presented in italics.