Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 59)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 43
Identifica-
tion Description Commands
.RAN Current, absolute rotation angle of
the rack in ° in relation to the axis
of the selected tower (entry when
ending the command) MOVE
.RE{x}.DRC Correlation coefficient for mean
dosing rate in window x (1…9) STAT
.RE{x}.DRS Standard deviation for mean dosing
rate in window x (1…9) in mL/min STAT
.RE{x}.DRT Mean dosing rate in window x (1…
9) in mL/min STAT
.RE{x}.RWL Lower limit of the evaluation win-
dow x (1…9) in s STAT
.RE{x}.RWH Upper limit of the evaluation win-
dow x (1…9) in s STAT
.RES Calculated result of the standard
addition in the selected unit STDADD
.RPO Current rack position (entry at time
of ending the command); 0 means
'not defined' MOVE
.RTE Reference temperature in °C MEAS Cond
.SAN Current, absolute swing angle of
the robotic arm in ° (entry upon
ending the command) MOVE, SWING
.SLO Electrode slope of the sensor used
for the command (in % for pH sen-
sor or mV for ISE sensor) or elec-
trode slope calculated from the
calibration (for STDADD and CAL
LOOP) DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS
T, MEAS Conc,
STDADD, CAL
LOOP, DOS
.SME Start measured value (measured
value after processing the start con-
ditions) in the unit of the measured
value DET, MET, SET,
KFT, KFC, BRC,
STAT