Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1165)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1149
Record message
on | off (Default value: on)
If this option is enabled, the message defined in the text box will be docu-
mented in the determination if the limits are exceeded. The run will not be
stopped.
Message by E-mail
on | off (Default value: off)
If this option is enabled, the message defined in the text box will be sent to
the address defined under [E-mail] in the event that the result limits are
exceeded.
[E-mail]
Opens the dialog window Send E-mail for defining the E-mail parameters
(see Chapter 2.6.1, page 86).
Acoustic signal
on | off (Default value: off)
If this option is enabled, an acoustic signal will be emitted in addition to the
message defined above when a limit is exceeded.
Action
Action
on | off (Default value: off)
If this option is enabled, one of the following actions will be executed in the
event that limit values are exceeded.
Selection Cancel determination | Stop determination and
series
Default value Cancel determination
Cancel determination
The determination is stopped and the next determination of the series is
started.
Stop determination and series
Both the determination and the series are stopped.
[Save as template]
Open the dialog window Save result template in order to save the result
parameters as template for the creation of new results (see Chapter
5.6.8.2.6.2, page 1152).