Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1271)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1255
6.3.3.2 Templates for input lines
6.3.3.2.1 Managing the templates for input lines
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Input lines... ▶ Templates for
input lines
In the dialog window Templates for input lines, client-specific bit-pat-
terns for scanning remote input signals can be defined which can be selected
with the command SCAN and in Manual Control. The table with the defined
templates cannot be edited, although it can be sorted according to the
selected column in increasing or decreasing sequence by clicking on the
column title
[New]
Generates a new template (see Chapter 6.3.3.2.2, page 1255).
[Edit]
Edits the selected template (see Chapter 6.3.3.2.2, page 1255).
[Delete]
Deletes the selected template.
6.3.3.2.2 Editing the templates for input lines
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Input lines... ▶ Templates for
input lines ▶ [New]/[Edit] ▶ New template/Edit template
With [New] or [Edit] the dialog window New template or Edit tem-
plate opens for entering a new template or for editing an existing template.
Signal name
Name of the pattern for the input signal.
Input 25 characters
Input signal
Entry of the bit-pattern for the input signal with exactly 8 characters. It is
possible to enter the characters
0 = Line inactive,
1 = Line active and
* = Any line status.
Selection Bit-pattern with 8 characters (0, 1, *) | ********
Default value ********
The input lines and bits are numbered from right to left:
Input 7 6 5 4 3 2 1 0
Bit 7 6 5 4 3 2 1 0