Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1426)

7.9 774 Oven Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1410 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Start-up
Shows the date on which the device was automatically added to the device
table.
Data storage under legal control
Indicates whether the balance has its own calibratable data memory.
Only visible and editable with Sartorius balances.
Selection
on | off
Default value off
Remarks
Remarks about the device.
Input 1000 characters
Default value empty
7.9.3 Properties - Tower
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Tower
On the tab Tower the tower parameters for the tower mounted on the
774 Oven Sample Processor are shown. These cannot be edited, but
must be set on the device itself via the keyboard.
Max. stroke path
Shows the lowest permitted lift position for the tower. A lift height of 0
mm corresponds to the "Home position", i.e. the lift is moved right to the
top.
Beaker sensor
Shows whether the beaker sensor for the tower is switched on or off. Each
time that a sample position is moved to the beaker sensor checks whether
a beaker is present or not.
7.9.4 Properties - Rack
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Rack
On the tab Rack the rack-specific data of the attached rack are shown.
Rack name
Shows the name of the rack attached. If no rack is in position then "-----" is
shown.