Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1313)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1297
6.6.3.6 Properties - Exchange unit
Tab: Configuration ▶ Titrants/solutions ▶ Properties ▶ Exchange unit
Hardware
Name
Freely definable designation for exchange unit.
Input 24 characters
Default value 'empty'
Type
Shows the type of exchange unit:
Selection EU | IEU
EU
Non-intelligent exchange unit without data chip.
IEU
Intelligent 806 Exchange Unit with data chip.
Order number
Order number of exchange unit. With intelligent exchange units the order
number is read off automatically and cannot be edited.
Input 24 characters
Default value 'empty'
Serial number
Serial number of exchange unit. With intelligent exchange units the serial
number is read off automatically and cannot be edited.
Input 10 characters
Default value 'empty'
Cylinder volume
Cylinder volume of exchange unit. With intelligent exchange units the cyl-
inder volume is read off automatically and cannot be edited. If in the method
you have selected a solution in a titration or dosing command then the
cylinder volume will be checked in the run.
Selection 1 mL | 5 mL | 10 mL | 20 mL | 50 mL
Default value 20 mL
Cylinder serial number
Serial number of cylinder. It is printed on new cylinders. With intelligent
exchange units it is read off automatically. It can be altered at any time, e.g.
if the cylinder has to be replaced.