Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 374)

4.7 Subwindow Results ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
358 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Table 36 Command STDADD
Column 2: Variable Column 3 Column 4 Column 5 Column 6
SLO SLO , mV , 1
ENP ENP , mV , 1
RES RES , "selected
unit" , 1
VAR VAR , "leer" , 3
Table 37 Command DOS pH
Column 2: Variable Column 3 Column 4 Column 5 Column 6
MR MR.MRT , mL/min ,
4 MR.MRS , mL/min ,
4 MR.MRC , "leer" , 3
Table 38 Command DOS U
Column 2: Variable Column 3 Column 4 Column 5 Column 6
MR MR.MRT , mL/min ,
4 MR.MRS , mL/min ,
4 MR.MRC , "leer" , 3
4.7.4 Results - Calculation #
Tab: Database ▶ Results ▶ Command name
For each calculation command the results and (if existent and desired) the
corresponding statistical evaluations are displayed on a separate tab Cal-
culation_#. The sequence of the shown results corresponds to that defined
in the calculation command. The display of the statistical evaluations can be
selected in the dialog window Properties result window
For every single result a maximum of the following information is displayed:
Result "Result name"
Result "Result name"
Display of the result with variable name.
Note
Only the last results having been calculated will be shown. For example,
if there are several commands that generate a result with the same name,
then the corresponding result data will be shown only for that command
that was the last to calculate the result. Nothing will be shown for the
other commands.