Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 97)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 81
Case('RS.IntermediateRes' > 5.5;"Intermediate result too
high";'RS.IntermediateRes' * 26.5;"Error occurred") = If the result
"IntermediateRes" is greater than 5.5, the text "Intermediate result too
high" will be written into the result, otherwise the intermediate result will
be multiplied by 26.5. If an error occurs during the comparison ('RS.Inter-
mediateRes' > 5.5), "Error occurred" will be saved as a result of this
operation.
2.4.4.9.2 Error
Dialog window: Formula editor ▶ Operators/Functions
Syntax
y = Error(value)
Gives +1 if the value is invalid (error) or 0 if the valie is valid. This function
can be used e.g. to check variables for their existence or validity.
Parameters
Value
The variable to be tested.
Examples
Error('RS.IntermediateRes') = 0: the intermediate result was able to be
calculated.
Error('RS.ZwischenRes') = 1: the intermediate result is invalid.
Error('DET pH 6.EP{1}.MEA') = 0: the variable for the measured value
exists at endpoint 1,
Error('DET pH 6.EP{1}.MEA') = 1: no variable for the measured value or
no EP exists.
2.4.4.10 ASCII table
Dialog window: Formula editor
Only characters that can be printed are listed in the table below:
ASCII value
(dec)
Characters ASCII value
(dec)
Characters ASCII value
(dec)
Characters
32 Space 64 At sign (@) 96 Accent grave (`)
33 Exclamation
mark (!) 65 A 97 a
34 Quotation mark
(") 66 B 98 b
35 Hash mark (#) 67 C 99 c
36 Dollar ($) 68 D 100 d