Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1274)

6.3 Configuration data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1258 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
6.3.3.4 Templates - Conductivity standards
6.3.3.4.1 Manage conductivity standards
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Conductivity stand-
ards ▶ Conductivity standards
Conductivity standards can be defined in the dialog window, which can
be selected with the command CAL Cond. The table cannot be edited.
[New]
Creation of a new conductivity standard. The window Edit conductivity
standard opens, in which a new conductivity standard can be defined (see
Chapter 6.3.3.4.2, page 1258).
[Properties]
Edits the selected conductivity standard. The window Edit conductivity
standard opens, in which the conductivity standard can be edited (see
Chapter 6.3.3.4.2, page 1258).
[Delete]
Deletes the selected conductivity standard.
[Copy]
Copies the selected conductivity standard, which is saved under the name
Copy of.....
6.3.3.4.2 Edit conductivity standard
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Conductivity stand-
ards ▶ Conductivity standards ▶ Edit conductivity standard
With [New] or [Properties] in the dialog window Conductivity stand-
ards, the dialog window Edit conductivity standard opens for entering
a new conductivity standard or for editing an existing conductivity standard.
Name
Name of the conductivity standard.
Input 25 characters
Comment
Comment on the conductivity standard.
Input 1000 characters
Measured observational pairs
Table with the value pairs for Temperature and Conductivity, which were
determined for the conductivity standard. The table cannot be edited, but
with a click on the column title the temperature can be sorted according to
either increasing or decreasing sequence.