Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 970)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
954 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Command variables
The following command variables are generated in the method run by the
command MEAS Conc and can be used in formulas under the designation
'Command name.Variable designation':
Identifica-
tion Description
.BLV Blank value of the sensor used for the command (only for
ISE sensors)
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.DBL Total duration for the processing of the command in s
.EME Final measured value (measured value after processing of
the command) in the unit of the measured value
.ENP Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point of
the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of the
measuring point list
.LP.MEA Measured value for the last measuring point of the meas-
uring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the measur-
ing point list in °C
.LP.TIM Time in s until the last measuring point of the measuring
point list is reached
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)