Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 668)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
652 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
￭ Additional measured values
Definition of additional measured values of other measuring commands
which are saved as additional columns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command SET pH and can be used in formulas under the designation
'Command name.Variable designation':
Identification Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.CBY Command status; 1 = Conditioning activated, 0 =
Conditioning deactivated
.COK Command status; 1 = Condition requirement ful-
filled, 0 = Condition requirement not fulfilled
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used
for the command
.DBL Total duration for the processing of the command in s
.DRI Current and/or last drift for drift correction in µL/min
.DSC Time for processing all start conditions s
.DTI Time for drift correction (time from the start of the
titration to the end of the command) in s
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.ENP Electrode zero point of the sensor used for the com-
mand (dimensionless)
.EP{x}.MEA Measured value for the endpoint × (1…9) in the unit
of the measured value
.EP{x}.MEP Quantity of endpoints in the window × (1…9); 1 = 1
endpoint, 2 = 2 or more endpoints, 3 = EP cor-
rected with Autodrift, 4 = EP corrected with
manual drift
.EP{x}.TEM Temperature for the endpoint × (1…9) in °C
.EP{x}.TIM Time in s until the endpoint × (1…9) is reached
.EP{x}.VOL Volume for the endpoint × (1…9) in mL