Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 383)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 367
Only editable when autoscaling is disabled.
Range
-1.00E+12 ... +1.00E+12
Default value -1.00E+12
End value
End value for scaling the x axis.
Only editable when autoscaling is disabled.
Range
-1.00E+12 ... +1.00E+12
Default value +1.00E+12
4.8.4.3 Curve properties - y1 axis
Dialog window: Database ▶ Curves ▶ Properties curves # ▶ y1 axis
Parameters for the graphical display of the curves on the y1 axis (left-hand
y axis).
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved per
curve window and per client.
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS Opt | MEAS Spec |
CAL Spec | KFT | KFC | BRC | STAT | DOS | TET
Default value DET
Note
When the dialog window is opened, those Command type will be selec-
ted as standard which applies for the curve shown in the curve window.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be
edited.
Size
Selection of the quantity to be shown on the y1 axis.