CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 152)

138
Moving PTZ Camera to a Preset Location upon
Alarm Event
It is possible to direct a PTZ camera to a present location upon an alarm event. The setup determines
how the PTZ camera moves to respond to an I/O-triggered event. Click the Configure button, point to
Accessories, click I/O Application, and select I/O Application Setting from the menu to bring up the
following dialog box.
Figure 2-8 I/O Application
The options here allow you to specify how the PTZ camera, and the GV-System will respond to an
I/O-triggered event. Click the Arrow buttons, and select a module and its input to set up.
„ Preset Go by I/O: Enable the option and select your PTZ camera from the drop-down list.
„ Addr: Specify the address of the PTZ camera.
„ Alarm On: Turns the PTZ camera to a preset point when the input is triggered.
„ Alarm Off: Returns the PTZ camera to a preset point when the triggered input is off.
„ Alarm On Dwell Time: Specify the amount of time the PTZ camera stays at “Alarm On” preset
point, before returning to the “Alarm Off” preset point.
[Never Recycling Input-Triggered Events] When the item is checked, the files of input-triggered
events won’t be recycled by the system when disk space is full.