CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 151)

I /O Applications 2
I/O Control Panel
I/O control panel is used to control I/O devices that are added to the system. This control panel will not
appear, unless at least one I/O device is connected to the system. To add and to configure a device,
see Setting Up I/O Devices earlier in this chapter.
I/O Input Control Panel
After a device is added to the system, click the I/O button on the main screen to bring out the on-screen
control panel for inputs and outputs (Figure 2-6 and Figure 2-7). If only one I/O device is connected to
the system, click the I/O button and select Module 1 to bring up the control panel; if more than one I/O
modules are connected to the system, clicking the I/O button will list all I/O modules connected to the
system. Select one to bring out the control panel.
Figure 2-6 Input control panel
The input panel displays status of current input sensors. The “walking man” icon indicates the sensor is
being triggered.
I/O Output Control Panel
Click the Out button to switch to the following output panel. Pressing an alarm icon will send an output
signal to the corresponding relay.
Module Number
Output Device
Figure 2-7 Output Control Panel
137