HP Storage Essentials Enterprise Edition Software - Manual (Page 743)

HP Storage Essentials SRM 6.0 User Guide 705
8. To modify the time-out period, set the corresponding property for your switch in the following
table to the number of millisecond you want. The default is 5000 ms. For example, to change
the time-out period to 30000 ms for a McDATA switch, you would set the
cimom.McData.Snmp.Timeout
property to 30000, as shown in the following example:
cimom.McData.Snmp.Timeout=30000
1. To modify the number of retries, repeat steps 4 through 6 by copying and pasting the property
specified in the table below. Set the corresponding property for your switch in the following table
to the number of retries you want. The default is two retries. For example, to change the number
of retries to five for a McDATA switch, set the cimom.McData.Snmp.Retries properties as
shown in the following example:
cimom.McData.Snmp.Retries=5
1. When you are done, click Save.
Table 159 Time-out Properties
Switch Property
McDATA/Connectrix
discovered through SNMP
cimom.McData.Snmp.Timeout
Cisco
cimom.Cisco.Snmp.Timeout
Other switches discovered
through SNMP:
• Sun StorEdge
• QLogic
cimom.snmp.switch.timeout
Table 160 Retry Properties
Switch Property
McDATA/Connectrix
discovered through SNMP
cimom.McData.Snmp.Retries
Cisco
cimom.Cisco.Snmp.Retries
Other switches discovered
through SNMP:
• Sun StorEdge
• QLogic
cimom.snmp.switch.retries