Nortel Networks 1000 - Manual (Page 810)

810 NTAK20 Clock Controller daughterboard
Table 336
Faceplate LEDs
State Definition
On (Red) NTAK20 is equipped and disabled.
On (Green) NTAK20 is equipped, enabled, and is either locked to a reference or is in free run
mode.
Flashing
(Green) NTAK20 is equipped and is attempting to lock (tracking mode) to a reference. If the
LED flashes continuously over an extended period of time, check the CC STAT in
LD60. If the CC is tracking this may be an acceptable state. Check for slips and
related clock controller error conditions. If none exist, then this state is acceptable,
and the flashing is identifying jitter on the reference.
Off NTAK20 is not equipped.
Each motherboard has five DTI/PRI LEDs and one clock controller LED.
The clock controller LED is dual-color (red and green). The clock controller
LED states are described in
Table 337 "Faceplate LEDs" (page 810) .
Table 337
Faceplate LEDs
State Definition
On (Red) NTAK20 is equipped and disabled.
On (Green) NTAK20 is equipped, enabled, and is either locked to a
reference or is in free run mode.
Flashing
(Green) NTAK20 is equipped and is attempting to lock (tracking
mode) to a reference. If the LED flashes continuously over an
extended period of time, check the CC STAT in LD 60. If the
CC is tracking this may be an acceptable state. Check for slips
and related clock controller error conditions. If none exist, then
this state is acceptable, and the flashing is identifying jitter on
the reference.
Off NTAK20 is not equipped.
Functional description
The main functional blocks of the NTAK20 architecture include:
• phase difference detector circuit
•
digital Phase Locked Loop (PLL)
•
clock detection circuit
• digital-to-analog converter
•
CPU MUX bus interface
•
signal conditioning drivers and buffers
• sanity timer
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.