Nortel Networks 1000 - Manual (Page 20)

20 Overview
Figure 1
IPE line cards shown installed in an NT8D37 IPE module
When installing line cards, follow these general procedures:
Step Action
1 Configure the jumpers and switches on the line card (if any) to
meet system needs.
2 Install the line card into the selected slot.
3 Install the cable that connects the backplane connector on the
IPE module to the module I/O panel.
4 Connect a 25-pair cable from the module I/O panel connector to
the Main Distribution Frame (MDF).
5 Connect the line card output to the selected terminal equipment
at the MDF.
6 Configure the individual line interface unit using the Analog
(500/2500-type) Telephone Administration program LD
10 for analog line interface units and Multi-line Telephone
Administration program LD 11 for digital line interface units.
--End--
Once these steps are complete, the terminal equipment is ready for use.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.