beautypg.com

Address of lineside t1 card to the mmi, T1 framing, T1 coding – Nortel Networks 1000 User Manual

Page 187: Dsx-1 length, Line supervision on t1 failure

background image

Installation and configuration

187

Address of Lineside T1 card to the MMI

The address of the Lineside T1 card to the MMI is made up of two
components:

The address of the card within the shelf

The address of the shelf in which the card resides

These two addresses are combined to create a unique address for the
card. The MMI reads the address of the card within the shelf from the card
firmware; however the address of the shelf must be set by this dip switch.

The shelf address dip switch can be from 0 – 15. 16 is the maximum
number of Lineside T1 IPE shelves (a maximum of 64 Lineside T1
cards) capable of daisy chaining to a single MMI terminal. For ease, it is
recommended that this address be set the same as the address of the
peripheral controller identifier in LD 97 for type: XPE. This is not possible
because the dip switch is limited to 16; however, this is not mandatory.

T1 framing

The Lineside T1 card is capable of interfacing with CPE or CSU equipment
either in D4 or ESF framing mode. Make the selection for this dip switch
position based on what type of framing the CPE or CSU equipment
supports.

T1 Coding

The Lineside T1 card is capable of interfacing with CPE or CSU equipment
using either AMI or B8ZS coding. Make the selection for this dip switch
position based on what type of coding the CPE or CSU equipment
supports.

DSX-1 length

Estimate the distance between the Lineside T1 card and the hardwired
local CPE, or the Telco demarc RJ48, for the carrier facility connecting the
Lineside T1 and the remote CPE. Make the selection for this dip switch
position based on this distance.

Line supervision on T1 failure

This setting determines in what state all 24 ports of the Lineside T1 card
appears to the Meridian 1 in case of T1 failure. Ports can appear to the
Meridian 1 as either in the on-hook or off-hook states on T1 failure.

Note:

All idle Lineside T1 lines go off-hook and seize a Digitone

Receiver when the off-hook line processing is invoked on T1 failure.
This may prevent DID trunks from receiving incoming calls until the
Lineside T1 lines time-out and release the DTRs.

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311

02.06

Standard

27 August 2008

Copyright © 2003-2008 Nortel Networks

.