Nortel Networks 1000 - Manual (Page 72)

72 Acceptance tests
Digitone receiver cards
Note: The DTR daughterboard connected to a QPC659 Dual Loop
Peripheral Buffer card cannot be assigned when the IPE shelf is used
in single loop mode.
Procedure 4
Testing digitone receiver cards
Step Action
Use this procedure to test a Digitone receiver (DTR) card, a DTR daughterboard,
or the DTR function on the NT8D18 Network/DTR card.
1 Log into the system:
LOGI (password)
2 See if the Digitone receiver to be tested is disabled: LD 34
STAT
The system responds with the terminal number (TN), or
numbers, of any disabled Digitone receivers.
3 If the Digitone receiver is disabled, enable it:
ENLR l s c u loop, shelf, card, and unit numbers
4 Test the Digitone receiver:
DTR l s c u loop, shelf, card, and unit numbers
If the system response is other than OK, seeSoftware
Input/Output Reference — Administration (NN43001-611) to
analyze the messages.
5 End the session in LD 34:
****
--End--
Line cards
Procedure 5
Testing line cards
Step Action
Use this procedure to test a line card.
1 Log into the system:
LOGI (password)
2 Perform a network memory test, continuity test, and signaling
test on a specific loop and shelf:
LD 30
SHLF l s
loop and shelf numbers
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.