Nortel Networks 1000 User Manual
Page 377
377
.
NT6D71 UILC line card
Contents
This section contains information on the following topics:
“Physical description” (page 378)
“Functional description” (page 378)
Introduction
The NT6D71 U Interface Line card (UILC) supports the OSI physical
layer (Layer 1) protocol. The UILC is an ANSI-defined standard interface.
The UILC provides eight two-wire full-duplex (not polarity sensitive)
U interfaces to connect ISDN BRI-compatible terminals over Digital
Subscriber Loops (DSL) to the CS 1000E, CS 1000M, and Meridian 1.
A description of the ISDN BRI feature is contained in ISDN Basic Rate
Interface: Installation and Configuration (NN43001-318).
You can install this card in any IPE slot.
Note:
A maximum of four UILCs are supported in an Media Gateway
and Media Gateway Expansion.
The NT6D71 U Interface Line Card (UILC) supports the OSI physical layer
(Layer 1) protocol. The UILC is an ANSI defined standard interface. The
UILC provides eight two-wire full duplex (not polarity sensitive) U interfaces
that are used to connect ISDN BRI compatible terminals over DSLs to the
Meridian 1. A description of the ISDN BRI feature is contained in ISDN
Basic Rate Interface: Maintenance (NN43001-718).
The NT6D71 U Interface Line Card (UILC) supports the OSI physical
layer (Layer 1) protocol. The UILC is an ANSI-defined standard interface.
The UILC provides eight two-wire full-duplex (not polarity sensitive)
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
02.06
Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.