Symptoms and actions, Diagnosis: the msdl card is disabled or faulty, System disabled actions – Nortel Networks 1000 User Manual
Page 409

System disabled actions
409
12
Tag the defective card(s) with a description of the problem and
return them to your Nortel representative.
--End--
Symptoms and actions
Explained here are some of the symptoms, diagnoses, and actions
required to resolve MSDL card problems. Contact your Nortel
representative for further assistance.
These explain the causes of problems and the actions needed to return
the card to an enabled state following installation or operational problems.
Symptom: The LED on the MSDL card is steadily lit.
Diagnosis: The MSDL card is disabled or faulty.
Action: Refer to
.
or
Diagnosis: Peripheral software download failed because of MSDL card or
system disk failure.
Action: If only one MSDL card has its LED lit, replace it.
Symptom: Autorecovery is activated every 30 seconds to enable the
MSDL. MSDL300 messages appear on the console or TTY.
Diagnosis: The MSDL card has been system disabled because of an
incorrect address.
Action: Verify the switch settings.
or
Diagnosis: The MSDL card has been system disabled because of
peripheral software or configuration errors.
Action: Refer to
“System disabled actions” (page 409)
System disabled actions
These explain the causes of problems and the actions needed to return
the card to an enabled state following system disabling.
SYSTEM DISABLED—NOT RESPONDING
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
02.06
Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.