Nortel Networks 1000 User Manual

Page 676

676

NT8D15 E and M Trunk card

These can be specified for the Meridian 1 end (near-end), or for the CO or
other PBX end (far-end). Joint party control can also be specified for the
far-end.

Release control of a call made over a trunk is specified in LD 16.
Disconnect supervision is specified for each trunk group independently.
The two options available are EITHER or ORIGINATING party control.
These can be specified for the CS 1000 end (near-end), or for the CO or
other PBX end (far-end). Joint party control can also be specified for the
far-end.

Release control of a call made over a trunk is specified in the route data
block (LD 16). Disconnect supervision is specified for each trunk group
independently.

Only incoming trunks in idle ground start configuration can provide
disconnect supervision. For a list of prompts and responses and default
conditions see Software Input/Output Reference — Administration
(NN43001-611).

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311

02.06

Standard

27 August 2008