Channel associated signaling, Incoming signal – Nortel Networks 1000 User Manual
Page 789
Architecture
789
cable. The impedance is switch set. The switch-settings table at the end
of this chapter describes the options. See
options" (page 800) “Switch settings” (page 799)
.
If a coaxial interface is required, use NT5K85 in conjunction with the
NTBK05.
Channel associated signaling
Channel associated signaling means that each traffic carrying channel has
its own signaling channel permanently associated with it. Timeslot 16 is
used to transmit two types of signaling: supervisory and address.
Channel associated signaling implies that each traffic carrying channel has
its own signaling channel permanently associated with it. Timeslot 16 is
used to transmit two types of signaling: supervisory and address.
Channel associated signaling means that each traffic carrying channel has
its own signaling channel permanently associated with it. Timeslot 16 is
used to transmit two types of signaling: supervisory and address.
Incoming signal
Functions of the NTAK10 with regard to incoming signaling include:
•
recognizing valid changes
•
determining which channels made the changes
•
collecting PPM
•
reporting changes to software
Functions of the NTAK10 with regard to incoming signaling include:
•
recognizing valid changes.
•
determining which channels made the changes.
•
collecting PPM.
•
reporting changes to software.
Functions of the NTAK10 with regard to incoming signaling include:
•
recognizing valid changes
•
determining which channels made the changes
•
collecting PPM
•
reporting changes to software
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
02.06
Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.