Nortel Networks 1000 - Manual (Page 301)

Man-Machine E1 maintenance interface software 301
Figure 71
Display Alarm (D A) screen
The Pause command can be used to display a full screen at a time, by
entering
D A P . If there is more than one screen in the log, the MMI scrolls
the log until the screen is full, then stops. When ready to see the next
screen, press any key. The display shows another screen and stops again.
This continues until the entire log has been displayed.
Clear Alarm Log
Clear all entries in the alarm log by typing the Clear Alarm Log (C A L)
command.
Display Status
The Display Status (D S) command displays the current alarm
condition of the E1 link as well as the on-hook or off-hook status of each of
the 30 ports of the LEI. Entering this command causes a screen similar to
Figure 72 "Display Status (D S) screen" (page 301) to appear.
The Pause command can be used to display a full screen at a time, by
entering
D S P . If there is more than one screen, the MMI scrolls until the
screen is full, then stops. When ready to see the next screen, press any
key. The display shows one more screen, and stops again. This continues
until the entire E1 link has been reported on.
Figure 72
Display Status (D S) screen
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.