Physical description – Nortel Networks 1000 User Manual
Page 160
160
NT5D11 and NT5D14 Lineside T1 Interface cards
such as the Nortel Norstar. The Lineside T1 card differs from trunk T1
cards in that it supports terminal equipment features such as hookflash,
transfer, hold, and conference.
This card occupies two card slots in the main or expansion cabinets. The
Lineside T1 card can be installed in the system’s main cabinet or one of
the expansion cabinets (there are no limitations on the number of cards
that can be installed in the Cabinet system).
The Lineside T1 card emulates an analog line card to the system software;
therefore, each channel is independently configurable by software control
in LD 10. The Lineside T1 card also comes equipped with a Man-Machine
Interface (MMI) maintenance program. This feature provides diagnostic
information regarding the status of the T1 link.
The NT5D11 Lineside T1 interface card is an IPE line card that can be
installed in the NT8D37 IPE module. Up to eight cards can be installed.
The Lineside T1 card interfaces one T1 line, carrying 24 channels, to the
Meridian 1 switch. This card occupies two card slots in the IPE shelf,
utilizing 16 channels on slot 1 and 8 channels on slot 2. The Lineside T1
card emulates an analog line card to the Meridian 1 software; therefore,
each channel is independently configured by software control in the Analog
(500/2500-type) Telephone Administration program LD 10. The Lineside
T1 card is equipped with a Man-Machine Interface (MMI) maintenance
program that provides diagnostic information regarding the status of the
T1 link.
The Lineside T1 card is an Intelligent Peripheral Equipment (IPE) line
card that interfaces one T1 line, carrying 24 channels to the Option 11C.
This card occupies two card slots in the main or expansion cabinets. The
Lineside T1 card can be installed in the system’s main cabinet or one of
the expansion cabinets (there are no limitations on the number of cards
that can be installed in the Option 11C system).
The Lineside T1 card emulates an analog line card to the Option 11C
system software; therefore, each channel is independently configurable
by software control in the Single-line Telephone Administration program
(LD 10). The Lineside T1 card also comes equipped with a Man-Machine
Interface (MMI) maintenance program. This feature provides diagnostic
information regarding the status of the T1 link.
Physical description
The Lineside T1 card mounts into any two consecutive IPE slots. The
card consists of a motherboard and a daughterboard. The motherboard
circuitry is contained on a standard 31.75 by 25.40 cm. (12.5 by 10.0 in)
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
02.06
Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.