Nortel Networks 1000 User Manual
Page 211
Installation and configuration
211
Table 87
DX-30 to T1 time slot mapping (cont’d.)
Item
TN
T1 Channel Number
Motherboard
4
5
Motherboard
5
6
Motherboard
6
7
Motherboard
7
8
Motherboard
8
9
Motherboard
9
10
Motherboard
10
11
Motherboard
11
12
Motherboard
12
13
Motherboard
13
14
Motherboard
14
15
Motherboard
15
16
Daughterboard
0
17
Daughterboard
1
18
Daughterboard
2
19
Daughterboard
3
20
Daughterboard
4
21
Daughterboard
5
22
Daughterboard
6
23
Daughterboard
7
24
Although much of the architecture and many of the features of the Lineside
T1 card differ from the analog line card, the Lineside T1 card has been
designed to emulate an analog line card to the Meridian 1 software.
Because of this, the Lineside T1 card software configuration is performed
the same as two adjacent analog line cards.
All 24 T1 channels carried by the Lineside T1 card are individually
configured using the Analog (500/2500-type) Telephone Administration
program LD 10. Use
Table 88 "DX-30 to T1 time slot mapping" (page
to determine the correct unit number and the technical document
Software Input/Output Reference — Administration (NN43001-611) for LD
10 service change instructions.
The Lineside T1 card circuitry routes 16 units (0-15) on the motherboard
and eight (0-7) units on the daughterboard to 24 T1 channels. The
motherboard circuit card is located in the left card slot, and the
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
02.06
Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.