Grass Valley Maestro Master Control v.2.4.0 - Manual (Page 59)

55 MAESTRO User Manual
Section 2 — The Maestro Configuration Editor
IP Address
Enter the IP address for the control system. For example:
• Encore control - enter the facility LAN (typically EN1) address for the
primary Encore SCB.
• Prelude control - enter IP address for the primary Prelude panel.
• Jupiter control using serial connection - no entry.
• Jupiter control using LAN connection - enter the IP address of the
primary CM-4000.
Redundant IP Address
Enter the alternative IP address for the control system. For example:
• Encore - enter the facility LAN (typically EN1) address of the redun-
dant Encore SCB (if any).
• Prelude control - enter IP address for the redundant Prelude panel.
• Jupiter control using serial connection - no entry.
• Jupiter control using LAN connection - enter the IP address of the
redundant CM-4000.
Baud Rate
Enter the Baud rate for the Jupiter serial connection.
Encore and Prelude - no entry.
Jupiter serial connection - select the baud rate for the Maestro “Router Con-
trol” port connection to the VM/CM serial port. The normal rate is “38400.”
This must agree with the VM/CM value established during Jupiter config-
uration.
Jupiter LAN connection - no entry.
Data Bits
Enter the Data bits for the Jupiter serial connection.
Encore and Prelude - no entry.
Jupiter serial - select “8.”
Jupiter LAN - no entry.
Stop Bits
Enter the Stop bits for the Jupiter serial connection.
Encore and Prelude - no entry.