Grass Valley Maestro Master Control v.2.4.0 - Manual (Page 185)

181 MAESTRO User Manual
Section 2 — Basic Maestro Operation
Transition Setup
Control over the source and the next transition are selected with the button
groups that are shown below in
Figure 109 .
Transition rates and types are selected with the button groups that are
shown in
Figure 110 on page 182 .
The Next Transition Button Group
The NEXT TRANSITION button group provides extensive control over what
happens when a Take occurs. For example, if only the Down Stream button
is enabled, then only the selected downstream keys will transition when
the next Take happens. Each of these buttons is explained below.
Figure 109. The SOURCE CONTROL and NEXT TRANSITION Button Groups
The Up Stream button will enable, and disable, all upstream transitions.
These Upstream transitions are the transitions between the PGM, PST, AUX
busses, including Wipes. The transitions include the four upstream keys
and all four audio mixers.
The Down Stream button will enable and disable all downstream transitions.
Only the four downstream keys are affected by this button.
The DVE button will enable and disable DVE effects. If a DVE effect is active
and the DVE button is turned off then Maestro will only operate on the
PGM Effect window in the currently active DVE effect.
Rate Selection
The Slow, Medium , Fast and Cut buttons in the RATE button group determine
the rate at which a transition takes place. The time is displayed in seconds:
frames. This time that is associated with each rate is determined by entries
in the Configuration Editor Channel Setup table.