Grass Valley Maestro Master Control v.2.4.0 - Manual (Page 330)

MAESTRO — User Manual 326
Visualization Tool
Follow these steps to add a font to the CGText Font list:
1. Click the Fonts button. The Fonts dialog will then appear ( Figure 218 ).
Figure 218. Visualization Tool - The Fonts Dialog
2. Click the Installed Fonts drop-down list. Arial has been selected in
Figure 218 above.
3. Adjust the font to the preferred size by entering the size in the Font size
(Scanlines) field.
Note The Font size must be set for each size of font that you want to use. The size
should change with every Video Standard change.
4. Select the Add to CGText Font List check box.
5. Click the Create Font File button. Maestro’s font tool will then begin to
process the font. The Save Font dialog will then appear ( Figure 219 ).
Figure 219. Visualization Tool - The Save Font Dialog
6. Click the OK button to close the dialog.
7. Select the new font from the Existing Internal Fonts drop-down list in
the lower section of the dialog.
8. Click the Add Font button. The font will then appear in the CGText Font
List ( Figure 220 on page 327 ).