Grass Valley Maestro Master Control v.2.4.0 - Manual (Page 218)

MAESTRO User Manual 214
Audio Controls
A bar-graph meter display will appear in the center of the screen. This
display is configured with the settings that are accessed by the
Opt button
(see page 229 ). The default is to display all defined audio channels for all
audio groups, with borders showing the audio groups around the meters.
These borders are highlighted for the audio group that was selected using
the soft buttons on the right of the VGA screen. The group name is dis-
played under the top edge of the border but above the bar-graph. See
Figure 139 .
Figure 139. Detail of Audio Panel, Showing Example of Group and Channel Names for Stereo Group
The scale displayed with the meters is configured by selecting either VU or
PPM on the Option screen. A phase symbol will be displayed above any
pair of meters that is defined as a stereo pair in the Configuration tables.
This symbol will light up Red when an out-of-phase condition is detected
in the hardware.
Below each bar graph is the abbreviation of the Channel name. The source
of this channel name is the Channel Name column of the Audio Output
table.
Note Due to space limitations, these names are likely to be truncated on this dis-
play.
8384_59
Group name
Channel name
Channel name