Grass Valley Maestro Master Control v.2.4.0 - Manual (Page 181)

177 MAESTRO User Manual
Section 2 — Basic Maestro Operation
Figure 108. GUI panel with Source Assign Panel Opened
Note A previously saved panel setup can be restored by pressing the Recall button.
Save/Recall functionality is described on
page 253 ).
Sources can be assigned one at a time to buttons by selecting one of the
Quick Pick sources and then selecting an available button on the Preset bus.
An available button will be illuminated green.
Sources can also be assigned by following the steps below:
1. Press the Send button.
2. Select the desired source (category and number).
3. Select an available button on the Preset bus (the available button will be
illuminated in green).