Synaccess Networks NP-0801DTM - Manual (Page 98)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 98
Parameters and Values
Enable flag.
0 Disable +CME ERROR: reports, use only ERROR report.
1 Enable +CME ERROR: reports, with in numeric format.
2 Enable +CME ERROR: reports, with in verbose format.
Notes
„
+CMEE has no effect on the final result code +CMS.
„
Reference: 3GPP TS 27.007.
Voice Control
DTMF Tones Transmission +VTS
Execute command allows the transmission of DTMF tones.
Test command provides the list of supported s and the list of supported s in the format:
(list of supported s)[,(list of supported s)]
Syntax
Command Command type
AT+VTS=[,duration] Execute
AT+VTS=? Test
Parameters and Values
String of s; that is ASCII characters in the set (0 9), #,*,(A D),P; it allows the
user to send a sequence of DTMF tones, each of them with a duration that was
defined through +VTD command
Duration of a tone in 1/100 sec. This parameter can be specified if only one ASCII
character is used in the dtmfstring.
0 A single DTMF tone is transmitted for a duration depending on the network, no
matter what the current +VTD setting is.
1‐255 A single DTMF tone is transmitted for a time (in 10 ms multiples), no
matter what the current +VTD setting is.
Notes
„
This command operates in voice mode only. See +FCLASS.
„
The character P does not correspond to any DTMF tone, but it is interpreted as a pause of 3 seconds between
the preceding and succeeding DTMF string elements.
„
Reference: 3GPP TS 27.007 and TIA IS‐101.