Synaccess Networks NP-0801DTM - Manual (Page 104)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 104
then the subscription value is requested.
String parameter that identifies the terminal in the address space applicable to
the PDP. The allocated address may be read using the +CGPADDR command.
Numeric parameter that controls PDP data compression
0 Off. If value is omitted, default: 0.
1 On.
Numeric parameter that controls PDP header compression
0 Off. If value is omitted, default: 0.
1 On.
, …, Zero to N string parameters whose meanings are specific to the
Notes
„
Reference: 3GPP TS 27.007
Examples
AT+CGDCONT=1,”IP”,”APN”,”10.10.10.10”,0,0
OK
AT+CGDCONT?
+CGDCONT: 1,”IP”,“APN”,”10.10.10.10”,0,0
OK
AT+CGDCONT=?
+CGDCONT: (1-5),”IP”,,,(0-1),(0-1)
OK
Quality of Service Profile +CGQMIN
Set command specifies a minimum acceptable profile that is checked by the terminal against the negotiated
profile returned in the Activate PDP Context Accept message.
Read command returns the current settings for each defined context in the format:
+CGQMIN: ,,,,,
[+CGQMIN: ,,
,,,[…]]
If no PDP context is defined, it has no effect and OK result code is returned.
Test command returns as a compound value the type of the current PDP context and the supported values for the
subparameters in the format:
+CGQMIN: ,(list of supported s),
(list of supported s),(list of supported s),
(list of supported s),(list of supported s)
Note: Only the “IP” is currently supported.