Synaccess Networks NP-0801DTM - Manual (Page 96)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 96
Read command reports the currently selected in the format:
+CCWE:
Test command reports the supported range of values for parameter .
Syntax
Command Command type
AT+CCWE= Set
AT+CCWE? Read
AT+CCWE=? Test
Parameters and Values
0 Disable call meter warning event. Default: 0.
1 Enable call meter warning event.
Set Voice Mail Number +CSVM
This command sets the number to the voice mail server. If the parameter is set to 0, you can omit the
parameters and .
Read command returns the currently selected voice mail number and the status (that is, enabled or disabled) in
the format
+CSVM:,,
Test command reports the range for the parameters and .
Syntax
Command Command type
AT+CSVM= [,[,]] Set
AT+CSVM? Read
AT+CSVM=? Test
Parameters and Values
0 Disable the voice mail number
1 Enable the voice mail number. Default: 1.
String type, phone number of format specified by .
Type of address octet in integer format.
129 Unknown type of number and ISDN/Telephony numbering plan.
145 International type of number and ISDN/Telephony numbering plan. Contains the
character "+".
Note: Set command only checks for parameters values validity. The command
does not actually write to SIM to update voice mail number.