Synaccess Networks NP-0801DTM - Manual (Page 189)

CUSTOM AT COMMANDS
189 HSPA+ AT Commands Reference Guide
Parameters and Values
0 Aborting the call setup by reception of a character is generally possible at any
time before the DCE enters connected state. Default: 0.
1 Aborting the call setup is disabled until the DCE enters connected state.
Read to I2C #I2CRD
Use this command to send data to an I2C peripheral connected to module GPIOs.
Test command reports the supported list of currently available s.
Syntax
Command Command type
AT#I2CRD=,,,,
AT#I2CRD=? Test
Parameters and Values
GPIO number for SDA . Valid range is “any input/output pin”. To determine the
range, use the Test command.
GPIO number to be used for SCL. Valid range is “any output pin” To determine the
range, use the Test command.
Address of the I2C device, with the LSB, used for read\write command. It does not
matter if the LSB is set to 0 or to 1. 10 bit addressing supported.
Value must be written in hexadecimal form, without 0x before.
Register to read data from. Range: 0‐255.
Value has to be written in hexadecimal form (without 0x before).
Number of data to receive. Range: 1‐254.
Data Read from I2C is dumped in Hex. See Notes section.
Notes
„
If data requested are more than data available in the device, dummy data ( normally 0x00 or 0xff ) is dumped.
„
At the end of the execution GPIO is restored to the original setting. See AT#GPIO command.
„
Device address, register address where to read from\ write to, and date bytes must be written in hexadecimal
form without 0x.
Examples
AT#I2CRD=2,3,20,10,12
#I2CRD: 00112233445566778899AABBCC
OK
Power Saving Mode Ring #PSMRI
Set command enables or disables the Ring Indicator pin response to an URC message while modem is in power
saving mode.
If enabled, a negative going pulse is generated when URC message for specific event is invoked. The duration of
this pulse is determined by the value of .