Synaccess Networks NP-0801DTM - Manual (Page 265)

E‐MAIL MANAGEMENT AT COMMANDS
265 HSPA+ AT Commands Reference Guide
AT#EADDR=? Test
Parameters and Values
String type, sender address. Any string value up to the maximum length reported
by the Test command. Default: empty string “”.
Examples
AT#EADDR="[email protected]"
OK
AT#EADDR?
#EADDR: "[email protected]"
OK
E‐mail Authentication User Name #EUSER
Set command sets the user identification string used during the authentication step of the SMTP.
Read command reports the current user identification string, in the format:
#EUSER:
Test command returns the maximum allowed length of the string parameter .
Syntax
Command Command type
AT#EUSER=[] Set
AT#EUSER? Read
AT#EUSER=? Test
Parameters and Values
String type, e‐mail authentication User ID.
Any string value up to maximum length reported in the Test command.
Default: empty string “”.
Note: If no authentication is required then the parameter is empty "".
Notes
„
This is a different user field than the one used for GPRS authentication. See #USERID.
Examples
AT#EUSER="myE-Name"
OK
AT#EUSER?
#EUSER: "myE-Name"
OK