Synaccess Networks NP-0801DTM - Manual (Page 196)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 196
Notes
„
The values are stored in non‐volatile memory and available on following reboot.
„
For possible encryptions see test command response.
Examples
AT#ENCALG?
#ENCALG: 5,2,1,1
OK
AT#ENCALG=5,1
OK
Sets the GSM encryption algorithm A5/1 and A5/3, and the GPRS encryption algorithm GEA1. It is available at the
next reboot.
AT#ENCALG?
#ENCALG: 5,2,1,1
The last two values indicate that the last used GSM encryption algorithm is A5/1 and the last used GPRS
encryption algorithm is GEA1.
After reboot
AT#ENCALG?
#ENCALG: 5,1,1,1
AT Run Commands
Enable SMS Run AT Service #SMSATRUN
Set command enables or disables the SMS AT RUN service.
Read command returns the current settings of and the value of in the format:
# SMSATRUN: ,
where:
Service status.
0 Not active.
1 Active.
Test command returns the supported values for the SMS AT RUN parameters.
Syntax
Command Command type