Synaccess Networks NP-0801DTM - Manual (Page 152)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 152
Syntax
Command Command type
AT#PCT Execute
AT#PCT=? Test
Notes
„
When +CPIN is in the READY state then #PCT is not applicable.
Extended Reset #Z
Set command loads both base section and extended section of the specified user profile stored with AT&W and
selected with AT&P.
Test command tests for command existence.
Syntax
Command Command type
AT#Z= Set
AT#Z=? Test
Parameters and Values
0 User profile 0.
1 User profile 1.
Periodic Reset #ENHRST
Set command enables or disables the unit reset after minutes.
Read command reports the current parameter settings for # EHNRST command in the format:
# EHNRST: < mod >[,,]
‐ time remaining before next reset
Test command reports supported range of values for and .
Syntax
Command Command type
AT#ENHRST=[,] Set
AT#ENHRST? Read
AT#ENHRST=? Test
Parameters and Values
0 Disables the unit reset. Default: 0.
1 Enables the unit reset one time.
2 Enables the periodic unit reset.
Time interval after which the unit reboots. Numeric value in minutes.