Synaccess Networks NP-0801DTM - Manual (Page 251)

FTP AT COMMANDS
251 HSPA+ AT Commands Reference Guide
Text row number 8 * 88888888888888888888
OK
AT#FTPRECV=200
#FTPRECV: 200
88888 *
Text row number 9 * 9999999999999999999999999 *
Text row number 10 * AAAAAAAAAAAAAAAAAAAAAAAAA *
Text row number 12 * BBBBBBBBBBBBBBBBBBBBBBBBB *
Text row number 13 * CCCCCCCCCCCCCCCC
OK
Note: To check when you have received complete file you can use AT#FTPGETPKT read command:
AT#FTPGETPKT?
#FTPGETPKT: sample.txt,0,1
OK
( set to 1)
FTPAPPEXT #FTPAPPEXT
This command sends data on a FTP data port while the module is in command mode. FTP data port must be
previously opened through #FTPPUT (or #FTPAPP) with parameter set to command mode
connection.
Test command reports the supported range of values for and .
Syntax
Command Command type
AT#FTPAPPEXT=[,]
AT#FTPAPPEXT=? Test
Parameters and Values
Number of bytes to be sent.
1‐1500
Data port closure.
0 Normal sending of data chunk.
1 Close data port after sending data chunk.
The device responds to the command with the prompt and waits for the data to send.
When bytes have been sent, operation is automatically completed.
If (all or part of the) data are successfully sent, then the response is:
#FTPAPPEXT: